Independent CO100Ar probes have been developed and manufactured, to allow flexible verification of the presence of Carbon Monoxide. The probe is fitted with an electrochemical cell sensor and is managed by a microprocessor that not only provides alarm signals to the devices connected to it, but can also directly control any kind of externalities. does […]
Independent CO100Ar probes have been developed and manufactured, to allow flexible verification of the presence of Carbon Monoxide. The probe is fitted with an electrochemical cell sensor and is managed by a microprocessor that not only provides alarm signals to the devices connected to it, but can also directly control any kind of externalities. does use integrated relay. This probe is useful when exceeding the set maximum CO concentration limit of 300 ppm, and when low CO concentrations persist in the environment for long periods of time and on the principle of accumulation can also be harmful to life. human. There are two outputs in the probe:
The second output is connected as needed for linear detection of 4 to 20 mA, but with a bottom rate of 300 ppm.
Power supply: 12 24 V. dc ± 10%
Power demand: 1 W maximum @ 13.8V
Alarm front relay: 10A SELV
Main alarm error: 10A SELV
Sensor and protection: Electrochemical cell,
Measurement range: 0 to 1000ppm
Dangerous alarm threshold: From 30 to 300ppm
Output signal: 4 20 mA
Data transfer: Not present
Service portal: current
Test time: 90 seconds
Operating temperature: -20 ° C to + 50 ° C
Degree of protection: IP65 case
Compatible control unit: whole range
Case and size: Aluninium -100x100x60
Packaging: 197x122x67
Weight: 300 grams approx